4 Channel Injector Driver 2 - Product Support Page
Last updated 1/18/14

Basic instructions:

• Injector driver is designed to be installed to control a second set of injectors.

Wiring instructions:

Main wiring harness:

• Red wires are +12 volt switched ignition power fused at 10amps
  Connect both red wires together
• Black wires are ground, connect to a good clean chassis ground
  Connect both black wires together
• Blue wire splices with injector #1 output from ECU
• Yellow wire splices with injector #2 output from ECU
• Green wire splices with injector #3 output from ECU
• Brown wire splices with injector #4 output from ECU
• White wire is the enable when low input normally used
  Enables injectors when this input is connected to ground
• Orange wire is the enable when high input not commonly used
  Enables injectors when this input is connected to +12VDC

Injector wiring harness: (pre-wired harness)

• Blue wires are for injector #1
• Yellow wires are for injector #2
• Green wires are for injector #3
• Brown wires are for injector #4

Confused? Contact us at sales@forcedfour.com