|
Our Injector
Drivers are designed to be plug and play with ECMLink for DSM's Our Peak & Hold Fuel
Injector Driver modules allows ECU’s that have a saturated
injector drive circuit to trigger low impedance injectors
with a true Peak & Hold injector drive circuit. Designed
for high performance cylinder engines.
Our Single Channel Peak & Hold Injector Driver contains
1
injector drive channel. Each channel supplies full battery
voltage to a fuel injector for rapid current rise, in order
to produce a positive injector opening. When load current
reaches ~4Amp the injector driver reduces the load current to
~1Amp and operates as a saturated constant current driver. This condition holds the injector open reducing
current draw from the electrical system and prolonging the
fuel injectors life. If the current fails to reach 4Amp
within ~5ms, the driver module automatically reduces the load
current to 1Amp to prevent damage to the injector.
- Smaller, lighter, more
efficient, more versatile
- Single Channel true Peak & Hold low
impedance fuel injector driver
- 100% Electronic Solid State
control with no mechanical relays required
- Use to add 1 additional fuel
injectors or to drive the existing injector
- Add meth injection with ECU
control to the UICP or pre turbo using a standard fuel
injector
- Operating Voltage: 8-18VDC with
negative ground
- RPM Capability: Unlimited
- Injector Triggers: 1
- Enable Triggers: 1 (active low)
- Trigger Waveform (white wire): Output is
activated when input trigger is grounded
- Trigger Impedance (white wire):
1K Ohm input
impedance, pulled up to 12VDC
- Injector Trigger Impedance: 220 Ohm input
impedance, pulled up to 12VDC
- Output Current Peak: 4Amp Peak
(other current levels available)
- Output Current Hold: 1Amp Sustain
- Peak Current Timeout: 5mS
- Protection: Injector inputs are optically
isolated
- Injector Driver harness: 30" length
- Pigtail allows you to fit to your own harness
- Dimensions: 1" x 1" x
0.50"
- Weight: 2oz
- Limited 1 year warranty
- Retail price ONLY $99.99
|
|
|
IN STOCK |
Disclaimer: Forced Four, and
the employees of Forced Four are not responsible for any
damage or personal injury caused by the misuse, improper
installation, product glitches, or product failures.
By installing this product and using this product, you are
agreeing to this disclaimer. Forced Four will stand behind
the quality of our products, and will try to correct any
issues you may have while using this product, but are in no
way liable for what this product may do.
Added to catalog on 8/8/16
|
