SMART PRND
Module V2 -
Product Support Page
Last updated
10/10/2024
SMART+ PRND32L Module
Version 2.0
Wiring
instructions:
1.
W/Black
wire connect to PARK
-
W/Grey
wire connect to the REVERSE
-
W/Yellow
wire connect to NEUTRAL
-
W/Brown
wire connect to DRIVE
-
W/Purple
wire connect to 3rd (Optional)
-
W/Green
wire connect to 2nd
-
W/Blue
wire connect to LOW
-
N/C
Input
not used
-
Grey
wire is shift selector common, required for proper
operation (+12V or Ground)
-
Orange
wire outputs 0-5V analog voltage for interface to SMART
TCM, ECU, or data logger
-
Black
wire connect to sensor ground, or chassis ground at TCM
-
Red
wire connect to fused +12V ignition switched power,
shared with TCM
Back view of connector notch up
|
1
Park
W/Black |
2
Reverse
W/Grey |
3
Neutral
W/Yellow |
4
Drive
W/Brown |
5
3rd
(Optional) |
6
2nd
W/Green |
|
7
Low
W/Blue |
8
N/C
|
9
Common
Grey |
10
Output
Orange |
11
GND
Black |
12
+12V
Red |
Usage:
·
Wire as instructed, insulate any unused wires
·
Mount in a suitable location under the vehicle dash
·
Common wire connect to +12V for active low inputs, OR
connect to GND for active high inputs
·
Orange wire outputs:
|
Function Table |
|
Pin
Active to 12VDC |
Shift Selector Position |
Output VDC |
|
W/Black |
Park |
0.25
VDC |
|
W/Grey |
Reverse |
1.00
VDC |
|
W/Yellow |
Neutral |
1.75
VDC |
|
W/Brown |
Drive |
2.50
VDC |
|
W/Purple |
3rd |
3.25 VDC |
|
W/Green |
2nd |
4.00
VDC |
|
W/Blue |
Low |
4.75
VDC |
Confused? Contact us at
sales@forcedfour.com
|
